Description
Optimized for Multi-Rotor Stability
This ESC is a staple in the DIY drone community, specifically tuned for multi-rotor applications. It features high-quality MOSFETs that handle up to 30A of continuous current, with a burst capacity of 40A for those moments when you need sudden punch-out power. The firmware is optimized for linear throttle response, ensuring that your drone reacts precisely to every stick movement from your transmitter.
Integrated Power & Protection
Safety and convenience are built-in. The integrated Battery Eliminator Circuit (BEC) outputs a regulated 5V, allowing you to simplify your wiring by eliminating the need for a separate battery for your electronics. It also includes comprehensive protection features such as Low-Voltage Cutoff (to protect your LiPo), Overheat Protection, and Throttle Signal Loss Protection, which automatically cuts power if the radio link is interrupted.
Key Features
-
High Refresh Rate: Supports high-speed signal input for faster flight controller corrections.
-
Built-in 2A BEC: Powers your receiver and flight controller (e.g., APM, Pixhawk, or KK2) directly.
-
Plug-and-Play Setup: Factory calibrated for standard throttle ranges (1ms to 2ms).
-
Thermal Management: Large aluminum heatsink under the yellow heat-shrink for efficient cooling.
-
Broad Motor Support: Works seamlessly with A2212, DJI 2212, and other common 22xx series motors.
Technical Specifications
| Specification | Details |
| Continuous Current | 30A |
| Burst Current (10s) | 40A |
| Input Voltage | 2S – 3S LiPo (7.4V – 11.1V) |
| BEC Output | 5V / 2A (Linear Mode) |
| Max Speed | 210,000 RPM (2-pole motor) |
| Firmware | SimonK / Hobbywing Based |
| Dimensions | 45mm x 24mm x 11mm |
| Weight | 25g |
Reviews
There are no reviews yet.